A technologically complex production can easily be executed on dedicated stamping centers.

The core of this kind of equipment is represented by a mechanical press, normally in a version which is a specific one for the required production.

Any drive type is available in the versions: eccentric, knuckle joint, link-drive; one, two, four connecting rods or in more complex combinations with one or more rams.

The Colombo Agostino engineering service will study and offer the most rational solutions for the automation and reduction of dead times.

Fairly balanced solutions of coil lines, transfers, robots allow to optimize any solutions to stamping problems.

Generally, despite the high specificity of this kind of equipment,
it is possible to get a good flexibility level so that productions different  than the original ones can be easily achieved on the same line.